Review by Joshua Schreiber for VideoSecu full motion articulating tilting swivel TV LCD wall mount bracket arm for 37″-55″ LCD LED LFD TV Super Strong Single Arm 27″ Extension Swivel Flat Panel Television LCD Plasma Tilt Wall Mount Free 7 ft HDMI cable W13
Rating:
I’ve had the swivel mount for a few weeks now and I’m so glad I purchased this model. It was an easy set up and does everything its supposed to. I was a little leary to put our 42″ 60lb tv on it up in the air, but once we got it all set up it was the best decision I’d made. I was thinking of just buying an angled mount without the extension capabilities, but that would have been such a pain to get all the wiring hooked to and hidden behind the tv. With this set up we are able to make easy cable adjustments, and either pull the tv out, angle it further up or down and push it back to the wall to give it a more fit look. I strongly sugges purchasing this product and would buy it again if I needed to.

Review by Scott for VideoSecu full motion articulating tilting swivel TV LCD wall mount bracket arm for 37″-55″ LCD LED LFD TV Super Strong Single Arm 27″ Extension Swivel Flat Panel Television LCD Plasma Tilt Wall Mount Free 7 ft HDMI cable W13
Rating:
This is the best shelf I could find for the price. If you want a shelf with a lot of adjustability this is the one. I have a 46″ Vizio LCD TV mounted to it and it works great. Just a couple of things you should know. Make sure you tighten all bolts down at the time of assembly so that the mount does not lean or sag. Also the instructions are terrible. Actually they are practically none existant. If you are not mechanically inclined then this mount is not for you. I am a mecahnical engineer who does not usually read the instructions anyway so it was not that bad. One thing I did learn the hard way is that when you mount it to the wall do not install the front plate the TV mounts too until after you have it on the wall. Once the arm is on the wall then install the front plate and hang your TV on it. The bad instructions are the reason that I did not give it 5 stars.

Review by Robert for VideoSecu full motion articulating tilting swivel TV LCD wall mount bracket arm for 37″-55″ LCD LED LFD TV Super Strong Single Arm 27″ Extension Swivel Flat Panel Television LCD Plasma Tilt Wall Mount Free 7 ft HDMI cable W13
Rating:
After extensive searches I settled on this one for it’s 22″ (min 5″, max 27″) extension – more than most of the others.

In my situation we do 95% of our viewing in a small den, and 5% of the time we need to turn the TV close

to 90 degress to open up to a bigger crowd in the living room. So I wasn’t too concerned about frequent adjusments.

And I needed 22″ extension to be able to swivel a 47″ TV that far.

Despite some concerns after reading reviews, the item arrived assembled and instructions were clear.

All the mounting hardware was neatly packaged in plastic – all separated by type. Included are a variety of

screws and spacers to allow connecting the brackets to various TVs. Also includes 4 lag screws and washers for wall mount.

One review mentioned the TV would loosely slide once mounted – not true if you tighten up the appropriate bolts.

Steps: 1) secure wall bracket/arms to wall, 2) secure TV brackets to TV, 3) hang TV, slide to adjust positior, and secure lower bolts.

Item ship weight is listed at 50# (one of the reasons I bought it); during shipment UPS tracking showed 21# (I wasn’t too

happy at that point), on arrival it weighed in at 33#. Definitely strong enough to hold up the 47″ LCD TV.

Other reviews about difficulty in getting horizontal are correct. With that in mind I was sure to level the

screen bracket and attach the wall bracket accordingly. Note that the level can vary depending on which

way you swing in the arm. Also, with everything level I then extended the screen and turned it 90 degreees, and

it had a large tilt down. So I compensated further by putting a 3/16 space strip across the bottom of the wall

bracket. Then I adjusted the TV tilt knobs to match. Note that some side-to-side tilt can be adjusted for

by setting the tilt knobs at different positions.

The arm shipped very “tight” – hard to move. All pivots have adjustable tightness and hex wrenches are provided,

but relaxing these will add to any tilt problems so you’ll want them pretty tight. I am considering taking

mine apart to lubricate them. The dual arm mounts I would expect do not suffer as much from the leveling issues

as each arm could cancel out some of the slop of the other.

All-in-all, I am happy with the product at it’s $70 price (+$30 shipping), and now I see it is under $50 plus shipping.

I built a custom cabinet (closet makeover) and built a “rear” wall about 8″ back to account for the depth of the TV and

minimum depth of the bracket… this gives me a flush TV when fully stowed. Be sure to back this wall with STUDS

for secure bracket mounting!

On a side note, the 47″ 120Hz Vizio has a fantastic picture… like looking through a window for many shows.

120Hz or higher w/ motion control is a must!! (we upgraded from an older 42″ 60Hz Vizio).

Review by Brian C. Dang for VideoSecu full motion articulating tilting swivel TV LCD wall mount bracket arm for 37″-55″ LCD LED LFD TV Super Strong Single Arm 27″ Extension Swivel Flat Panel Television LCD Plasma Tilt Wall Mount Free 7 ft HDMI cable W13
Rating:
The instructions out of the box made it seem that the box included two different sets of pieces, one set to attach to the wall, and one set to attach to the TV. One set of instructions had tiny diagrams that vaguely show how the pieces are put together, let alone which bolts and washers need to be used. The other set of instructions had text but the diagrams were vague. I had friends helping with the installation and they were equally confused. It reminded me of a “how many engineers does it take…” joke. In the end, we had to improvise some of the installation, but the box provided an abundance of nuts and bolts to get the job done.

Once the 52″ 60lb TV was installed, I was more than satisfied with the end result. The TV can easily be adjusted to any viewing angle I want, with barely any physical effort.

Review by S. Croslin for VideoSecu full motion articulating tilting swivel TV LCD wall mount bracket arm for 37″-55″ LCD LED LFD TV Super Strong Single Arm 27″ Extension Swivel Flat Panel Television LCD Plasma Tilt Wall Mount Free 7 ft HDMI cable W13
Rating:
The mount was advertised as handling up to 135 lbs, but no way that is true. It supported my 65 lb flat screen but it was impossible to make it level with the articulating arm mount included. Depending on which way the articulating arm was positioned, the TV either leaned right or left. There is just too much stress on the center swivel point of the articulating arm. I ended up mounting my TV to a frame I built inside a recessed opening over the fireplace. Could have saved $40-$50 if I had just purchased a flat mount. The TV also leaned forward a couple of inches, which can be adjusted, so that was not a problem. Would not recommend this model for anything above about a 40 inch TV, maybe 40 lbs.

Review by J. Estes for VideoSecu ML10B Articulating Wall mount for 10″ to 22″ TV LCD Monitor Display Black VESA100/75 -1E9
Rating:
This mount is about the best I have seen yet. Looking locally, I couldn’t find anything for less than $60 -$80 (even walmart). This came home for about $25. It mounts easily, comes with all hardware, it is black, just like the TV I mounted and the cables I strap to it to get them out of the way. The swing is very smooth, there is very little rock (side-to-side). The tilt (pitch) is very sturdy but adjustble. I don’t have a single complaint about this unit.

Review by William B. Jellig for VideoSecu ML10B Articulating Wall mount for 10″ to 22″ TV LCD Monitor Display Black VESA100/75 -1E9
Rating:
I purchased this mount to hang a 15″ LCD TV, weighing less than 9 pounds (the specifications rate it up to 33 lbs). I carefully measured and used a level to mount the swing arm on the wall, but when I hung the TV, the position of the arms and the small amount of “give” between the arm segments caused the TV to hang at a slight, but noticable, angle. You can tighten the arm segment joints, which helps the problem somewhat, but you won’t be able to swing the arm around once tightened. The swivel adjustments only allow you to change the side-to-side angle and the vertical tilt, there is no way to fix the rotation of the set.

Review by Jeff Wiedemann for VideoSecu ML10B Articulating Wall mount for 10″ to 22″ TV LCD Monitor Display Black VESA100/75 -1E9
Rating:
This monitor arm is pretty cool, and great price point. I mounted a 26″ LCD TV weighing like 32 LBS. Have not had a problem with it. I did need to make a trip to the hardware store for some longer screws than what was provided to connect to my TV.

Review by DMill for VideoSecu ML10B Articulating Wall mount for 10″ to 22″ TV LCD Monitor Display Black VESA100/75 -1E9
Rating:
Nice product, fairly well built, and attractive black powder coating. I mounted a 26″ HDTV (22.8 lbs) on our bedroom wall. As others have mentioned, no rotation after installing makes it important that you measure carefully before drilling. Here’s a couple tips that should help your install.

Before proceeding, I suggest that you tighten the arm hinges (using the supplied Allen wrench) to where you think they should be. They were fairly loose on the mount that I received. Reason being … Their tightness changes the level of the TV bracket.

1st tip: First thing I noticed was that the top of the bracket that mounts on the TV was NOT parallel with the mount’s arms when the mount was folded flat. Therefore, I mounted the vertical wall bracket (plate) so that the TV bracket was level; this meant that the wall bracket was NOT perfectly vertical, but just a “scosh” off vertical.

2nd tip: Even doing this, the TV was still not exactly level; close, but not “perfect”. This time I took a round file to the screw holes on the TV bracket and elongated them to correct the rotation required to make the TV perfectly level. It didn’t take much filing; less than 1/8″.

That did it! TV hangs perfectly level now when flat against the wall, which is where it is used mostly. Swinging the TV out to “max” position from the wall, due to the slight “give” others have mentioned, the TV is a gnat’s off from level, but this is low priority and tolerable.

One other point: If your TV/monitor is wider than 26″, you won’t be able to get it completely perpendicular to the wall, something to consider.

Review by Judith Papos for VideoSecu ML10B Articulating Wall mount for 10″ to 22″ TV LCD Monitor Display Black VESA100/75 -1E9
Rating:
I purchased this wall mount on the basis of other reviews. It was perfect for our need. Installation was very easy, the bracket was well made, moves easy (side to side, up and down). I put a 15″ tv on it and I am well satisfied compared to other brackets that are 3 & 4 times the price. I give this bracket a 5 star rating.